Trenz Electronic GmbH
Carrier board for TEM0007 Microchip PolarFire SoC module (TEB2000-01-T001)
The carrier board may only be used in conjunction with the TEM0007.
Numero di variazione (MEPA): VAR-827003115
Codice produttore: TEB2000-01-T001
Codice doganale:
Articolo situato in e spedito da: Riedlingen, Germania
The Trenz Electronic TEB2000 carrier board provides functionality for development, evaluation and testing purposes of Trenz 4 x 5 cm SoMs (System on Module).
The carrier board is equipped with a broad range of various components and connectors for different configuration setups and needs. On-module functional components and multipurpose I/Os of the SoM's logic are connected via board-to-board connectors to the carrier board components and connectors for easy user access.
See page "4 x 5 cm carriers" to get information about the SoMs supported by the TE0703 carrier board.
Key Features
- On Board
- System Controller (SC) (LCMXO2-1200HC-4TG144I1))
- Mini USB for JTAG and UART connection (FTDI FT2232H)
- Mini USB second UART connection (FTDI FT230XQ)
- SDIO port expander
- 4 x User LEDs
- D1, D2 connected to SC (firmware-dependent functionality)
- D3, D4 connected to SC and 4 x 5 SoM
- 2 x User push button
- Connected to SC (firmware-dependent functionality)
- Currently used for Hard- and Soft-Reset
- 4 User DIP switches
- Enable/disable update of the SC
- MIO0 (accessible signal by SC and SoM)
- 2 "mode" bits
- Interface
- Trenz 4 x 5 SoM socket
- 3 x Samtec LSHM series high-speed connectors
- Micro SD card connector
- 2 x VG96 backplane connectors assembly option (mounting holes and solder pads)
- Mini or Normal USB for SoM USB-OTG connection (depends on assembly variant)
- RJ45 GbE connector
- Power
- Overvoltage-, undervoltage- and reversed- supply-voltage-protection
- Barrel jack (2.1 mm) for 5V power supply input
- Size
- 10 x 6.45 cm
Scope of Delivery
- 1 x TEB2000-01-T001 Carrier board for TEM0007 Microchip PolarFire SoC module
Note: VG96 Connector vertical (article 21545), Harting DIN41612 (female) is not included in the scope of delivery, but can be purchased as an accessory in the shop.
Info: M2.5x8 mm screws and M2.5 galvanized nuts are required for mounting the VG96 connector.
Additional Information
- Manufacturer's article number: TEB2000-01-T001
- Trenz Electronic Carrierboard TEB2000 Wiki
- Support Forum
All modules produced by Trenz Electronic are developed and manufactured in Germany.
